Core specification fields
| Field | What to verify | Common mistake |
|---|---|---|
| Working area | Usable X/Y/Z travel and maximum panel dimensions | Confusing table size with usable cutting size |
| Spindle / tools | Power, speed, quantity, tool positions and collets | Comparing spindle power without tooling/process |
| Vacuum system | Table zones, pump model/power and porous-board setup | Assuming every small part will hold equally |
| Drilling | Vertical/horizontal spindles, hole sizes and software input | Calling a side-hole machine a six-sided drill |
| Feed and rapid speed | Axis-specific values and test conditions | Treating rapid speed as cutting output |
| Control and drives | Exact controller, servo/drive brands and post-processor | Accepting generic brand descriptions |
| Utilities | Voltage, frequency, phase, air and extraction | Leaving factory compatibility until shipment |
Specification status by model
| Model | Catalog table | Action before purchase |
|---|---|---|
| YMK-I | Complete technical table not supplied | Request current configuration sheet |
| YMK-IV | Complete technical table not supplied | Request current four-spindle configuration |
| YMK-VS | Working size, power, speed and voltage published | Confirm options and revision |
| YZ-61/62 | Drilling groups, speeds, panel range and power published | Confirm whether YZ-61 or YZ-62 applies |
| YM-102 | Panel range, speed and spindle data published | Confirm tooling, hole range and workholding |
Build an acceptance test
- Select representative panels, including the smallest part and hardest material.
- Define dimensions, hole position/depth, edge quality and repeatability tolerances.
- Run the real toolpath, not only a no-load motion demonstration.
- Record cycle time and interruptions separately from rapid speed.
- Document the controller screen, tooling, components and finished workpiece.
Request the current model specification
Send panel size, material, required operations, target output, voltage and destination country.
Wood CNC router specification questions
Does a 9 kW spindle automatically cut faster?
No. Output also depends on cutter, material, depth per pass, feed rate, machine rigidity, vacuum hold-down, toolpath and dust extraction.
What does a 1325 CNC router working area cover?
It generally covers standard 4 × 8 ft sheets. Verify the usable cutting area, gantry clearance, tool-change position and how the sheet is loaded.
How should CNC router accuracy be checked?
Define the test part, measuring points, tolerance, material, temperature and measuring tool. A single positioning figure does not prove finished-part accuracy.
What electrical details must be confirmed?
State voltage, frequency, phase, available power, grounding and local plug or cabinet requirements. Confirm every motor, pump and auxiliary device in the same electrical schedule.
Reviewed by the Yongmao product team on 22 October 2026. Confirm the current machine configuration in the quotation before ordering.